Yamaha CA 50 M (1984–1987) — Specs

Identity
Manufacturer: Yamaha
Model: CA 50 M
Category: Motorcycle
Type: Motorcycle
Years: 1984 → 1987
Engine
Displacement (cc): 49
Cylinders: 1
Power (hp): 3
Power (kW): 2
Dimensions

Overall length: 1830 mm
Overall width: 700 mm
Overall height: 1090 mm
Wheelbase: 1290 mm
Ground clearance: 115 mm
Tires
Front pressure (bar): 1.2
Rear pressure (bar): 2.2
Ignition
Spark plug: NGK BPR6HS
Plug gap: 0.7 mm
Fluids & Filters
Engine oil (without filter, L): 1
Air filter: OEM air filter
Service
Battery: OEM battery specification
Service interval (km): 3000
Service interval (months): 12
Parts and consumables for this motorcycle
Data is gathered with care, but without guarantee. Always confirm critical information with your dealer or workshop.
Service notes
Service interval: every 3,000 km or 12 months, whichever comes first. Engine oil: 1 L without filter change. Spark plug: NGK BPR6HS (gap 0.7 mm). Tire pressure: front 1.2 bar, rear 2.2 bar (cold). Always confirm critical values with the workshop manual or an authorised dealer.
OEM and quality aftermarket parts that fit this bike. Always confirm with your dealer before ordering.
Engine oil
Spec: 2-stroke autolube (JASO FC), separate mix-oil reservoir
- OEM OEM 2-stroke oil (JASO FC/FD)
- Premium Motul 710 2T (100% Synthetic)
- Premium Motul 510 2T Technosynthese (Semi-Synthetic)
- Standard Repsol Moto Sintetico 2T (Synthetic)
- Standard Elf Moto 2 Tech (Semi-Synthetic)
Fully Synthetic vs Semi-Synthetic
| Fully Synthetic | Semi-Synthetic | |
|---|---|---|
| Base oil | 100% chemical synthesis (ester or PAO) | Mineral oil + synthetic additives |
| Heat resistance | Excellent — stable at extreme heat & RPM | Good — suitable for normal temperatures |
| Cold start | Better — reaches engine faster when cold | Good — adequate for normal climates |
| Change interval | Longer (up to 10,000 km) | Shorter (5,000–7,000 km typical) |
| Price | Higher | Lower |
Oil filter
Spec: Not applicable — 2-stroke engine has no replaceable oil filter cartridge
- OEM 2-stroke engine — no engine-oil filter to replace.
- OEM Use the recommended 2-stroke oil grade listed above — clean oil is your only filtration.
Air filter
Spark plug
Spec: NGK BPR6HS, gap 0.7 mm
- OEM NGK BPR6HS
- Premium NGK BPR6HIX
- Standard NGK BPR6HS
Front brake pads
Rear brake pads
Front tire
Spec: 1.2 bar
Rear tire
Spec: 2.2 bar
Battery
- Premium Yuasa YTX5L-BS or YT4B-BS (typical 50-125cc)
Brake fluid
- Standard TotalEnergies HBF4
Coolant
Service interval
Spec: 3 000 km / 12 months
- OEM Engine oil + oil filter change
- OEM Air filter inspection
- OEM Spark plug check
- OEM Brake fluid replacement: every 2 years
Valve check
Spec: Not applicable — 2-stroke engine has no valves
- OEM 2-stroke engine — no valve clearance to inspect.
- OEM Inspect piston, rings and cylinder at engine rebuild intervals (~30–50 hours for race, longer for street).
- OEM Check exhaust power-valve operation (if equipped) every 20–30 service hours.
Drive chain
